apartment therapy changing the world, one room at a time

I've seen it happen. I have no idea how to fix it. Sadly no matter how much you pay for a throw pillow, it's all about the same quality when it comes down to how it was made. You might have been better off with a few cheaper ones to lean against.

Put a thin coat of clear nail polish on the underside of the fabric that's unravelling. That will usually stop it.

P.S. Just on the places that are unravelling -- not on the whole fabric.

Fabric stores usually carry a sort of clear glue/gel that is expressly for this purpose, it might be by the quilting supplies. If you can't find that, I'd just put some SuperGlue on it.

Ditto on the clear nail polish. I've used it to stop pantyhose from unraveling/ripping when a hole starts, I don't see why it wouldn't do the same for your pillows!

Hmmm, I don't have any advice but between the unraveling cushions and their saggy sofas I'm beginning to wonder if Room and Board is all hype without the quality to back it up...

If the pillow has a zipper, take out the insert, turn the cover inside out, and reinforce the seams with some stitches. If there isn't enough fabric I'd go for the nail polish solution.

And, if you saved the receipt, go back to PB & complain (clearance or not).

I would rip out the stitches surrounding the area and re-sew it by hand using a blind stitch. That's the only way you are going to completely get rid of the fraying area.

If you don't want to do that/can't do it, you can use Fray-Check to stop it from fraying further (http://www.amazon.com/Prym-Dritz-Fray-Check/dp/B0001DSIXW). I would apply it to the base of the area that is fraying, let it dry, and then trim off the excess fabric that has frayed. Just be careful not to cut into the fabric that has not frayed.

1. Get a ballpoint pen.

2. Remove the ink by unscrewing the end and pulling the ink out.

3. Poke the edges of the pillow corner back under with the pointy, inkless end of the pen.

4. Take a similar colored thread and stitch the corner closed with very tiny coil stitches around the corner.

Voila! Pillow fray fixed with no glue (which will make it hard, sharp, and crusty).

Fray check has been mentioned and it works, but any fabric glue (they usually stay soft) would be better than fingernail polish or Super glue, if you can get some. I'd poke the fraying bits back into the pillow at the seam with a toothpick or something, then carefully use the toothpick with a tiny bit of glue on it to insert inside the part that is fraying. Pinch over the toothpick while gently pulling it out to keep the glue inside and you should be good. (If you succumbed to the Magic Mendit ads, this is a use!)

But I agree, I'd complain to the store -- pillow fights might lead to fraying, but leaning shouldn't!

In addition to trying one of the DIY fixes, I'd contact Room and Board customer service letting them know about the issue you are having. They may be willing to send you new pillow covers gratis.

Another option would be to box the corners - I've done that to a few of my Danica ones and they look great.

http://www.marthastewart.com/goodthings/tailored-throw-pillows?autonomy_kw=pillow%20corner&rsc=header_1

I would be wary of using super glue. It can turn a foggy white, especially when used on plastics (though I'm assuming this isn't the case). Also, for general fix-it use, it can be really brittle. Tacky glue is generally a better choice.

I'll add my voice to the Fray-Check idea - I've used it on nylons, and it's much better than nail polish because that fabrics stay soft.