We're back to pallets, and this time a reader is sharing with us her thrifty backyard project: pallet loungers! We thought the result was pretty great-looking, and she agreed to let us publish her tutorial so you could try it out for yourselves.This tutorial comes courtesy of Shoestring Pavilion:
What You Need
Four pallets of the same size, preferably rectangular
One pallet slightly wider than your other pallets, more square than rectangular
Scrap 2x4s or pallet scraps of the 2x4 kind
Hammer and nails
1. "Take your four pallets of the same size and stack them on top of each other two by two. No need to secure them, the weight of the wood holds them in place just fine."
2. "Make sure your one remaining pallet is wide enough to fit as a back rest. A pallet usually consists of three layers of wood: the top boards, the middle boards (often 2x4s) and the bottom boards. In this case the top boards need to be long enough to fit as a back rest while still accommodating the 2x4s on each side of the seat. So they need to be the width of the seat plus at least 4 more inches. If they're an inch or two longer than that you don't have to be so precise and it'll make your life easier."
3. "Now it's time to deconstruct the back rest pallet and here's where the hard physical labor comes in... Remove all the bottom boards of the pallet and the two outside middle boards. Leave the one or two (depending on how your pallet is constructed) 2x4 boards in the middle where they are to help you keep the top boards in place. Save all the scraps, some will be used later in this project."
4. "Cut the remains in two halves. Make sure you cut so the slats will be in the same direction as your seat."
5. "Take your 2x4s, either from another pallet like I did or use new from the lumber yard, and attach them to the top boards on either side. These need to be longer than your back rest so they can reach down and fit next to the seat pallets."
6. "Prop your seat back up where you want it to go to determine how much of an incline you want the back to be. I marked the incline of the supporting legs on the side so I knew at what angle to attach the legs later (see pic with arrow). I just reused the original middle boards (2x4s) from my back rest pallet for this and at this point I was so tired and hot that I didn't even worry about cleaning them up. They'll barely be visible in the end anyway. Oh, and I attached the support legs to the back rest at this point, too."
7. "Attach the back rest pallet to the seat pallets. I was originally going to leave the back rest unattached but it was a little too wobbly so I put a screw where the arrow in the below pic is, one on each side of the lounger. It's only attached to the bottom seat pallet, the top one is still loose and removable."
Additional Notes: "And only two months later I finally got to the painting part! Mostly since bright red paint for the outdoor furniture wasn't a high priority in the spending budget. But last week I found Pratt & Lambert exterior paint in "Red Statement" for only $10 a gallon at our local Habitat store and the rest is history...
Now they just need some cushioning, a few pillows and I'm thinking a drop cloth canopy so we can finally start using them... These loungers were free except for the $10 for paint. I barely used a quarter of my gallon so I have plenty left for other projects. Not bad for backyard style!"
Via: Shoestring Pavilion
Want more smart tutorials for getting things done around the home?
See more How To posts
We're looking for great examples of your own household intelligence too!
Submit your own tutorials or ideas here!
(Images: Titti of Shoestring Pavilion)